Command Quick Reference
D-19
Comm protocol display 525 ECPS Px Txx Xx S0
P0 = basic
P1 = ECP
P2 = data inquiry
Txx = ECP timeout
ms = 50 * xx
TFF = disabled ECP timeout
X0 = no flow control
X1 = software flow control
X2 = hardware flow control
S0 = SOM character is #
Command mode switch 01 Done
Data inquiry protocol enable 613 Done
Data mode switch 00 Done
Date set 21 Done
Default operating parameters
load (except RF operating
frequency)
66F Done
Disable EAC page append 320 Done
DSP board Actel version display 513 DSP FPGA VER = XX.XX
eATA disable 488 Done
eATA enable 489 Done.
Echo disable 6170 Done
Echo enable 6171 Done
Echo status display 537 ECHO x
0 = disabled
1 = enabled
ECP protocol select 611 Done
ECP timeout set
NN = 01–FE (1–255)
timeout = 50 ms * NN
(if NN = FF, timeout is disabled)
612NN Done
ECP timeout set to 12.7 sec 612FE Done
eGo disable 482 Done
eGo enable 483 Done if Encompass 4 Reader
model supports this tag protocol.
Error if tag protocol is
unsupported.
Table D-3 Encompass 4 Reader Commands Listed Alphabetically (continued)
Command Name Code Reader Message
To Next Page
Loading...
