TransCore encompass 4 - Page 291

Command Quick Reference
D-27
User-programmable group se-
lect equals (GSE) filter set
697 MM AA DDDDDDDDDDDDDDDD
where
MM = determines which of the
eight comparison data bytes are
to be compared for the Group
Select filter
AA = determines the start ad-
dress in the tag memory for the
comparison data
D...D = 8-byte field (16 charac-
ters) used by the tag as the com-
parison data for the group select
filter
697 Done
Valid ID code select four 4203 Done
Valid ID code select one 4200 Done
Valid ID code select three 4202 Done
Valid ID code select two 4201 Done
Version display 505 Model [model] 
Ver [ver no.] SN [serial no.]
Wiegand mode disable 450 Done
Wiegand mode enable 451 Done
Wiegand mode status display 532 T0F x
0 = disabled
1 = enabled
Wiegand retransmit interval
display
533 WTI xx 
xx = 01–FF seconds
Wiegand retransmit interval set
NN = 01 to FF seconds
46NN Done
Wiegand retransmit interval set
to 1 second
4601 Done
Table D-3 Encompass 4 Reader Commands Listed Alphabetically (continued)
Command Name Code Reader Message