Encompass 4 Reader System Guide
D-26
Synchronization output delay
time disable
64800 Done
Synchronization output delay time
set NN = 01 to FF, where 01 = 1
ms and FF = 255 ms.
648NN Done
Synchronization values display 582
SYNC T<00 to FF> H<00 to 0A>
Tag ID separation select four 4103 Done
Tag ID separation select one 4100 Done
Tag ID separation select three 4102 Done
Tag ID separation select two 4101 Done
Tag translation mode status
display
534 TT <0 to 1>
0 = tag translation mode
disabled
1 = tag translation mode enabled
Time and date appended 302 Done
Time and date display 22 Time and date
Time and date not appended 300 Done
Time set 20 Done
Translation mode disabled 452 Done
Uniqueness reset 440 Done
Uniqueness timeout set to 2
minutes
441 Done
Uniqueness timeout set to 15
seconds
442 Done
Uniqueness timeout set to 30
seconds
443 Done
User-programmable group select
equals (GSE) filter data display
549 The response data is formatted
similar to the data in the
configuration command.
Table D-3 Encompass 4 Reader Commands Listed Alphabetically (continued)
Command Name Code Reader Message
To Next Page
Loading...
