Command Quick Reference
D-25
RF timeout set N = 0 to F
(always expired, 4,8,12,20,24,32,
48,60,92,152,300,452,600,752
ms, infinite)
693N Done
RF timeout set to infinite 693F Done
RF transceiver FPGA version
display
510 RF FPGA VER = XX.XX
RF transceiver I filter chip version
display
511 FIL IC I VER = XX.XX
RF transceiver Q filter chip
version display
512 FIL IC Q VER = XX.XX
RF0 filter status display 530 RF0S Ux Vx
U0 = one ID separation
U1 = two ID separations
U2 = three ID separations
U3 = four ID separations
U4 = transmit all IDs
V0 = valid ID code criteria of one
acquisition (fixed)
V1 = valid ID code criteria of two
acquisitions
V2 = valid ID code criteria of
three acquisitions
V3 = valid ID code criteria of four
acquisitions
SeGo disable 484 Done
SeGo enable 485 Done if Encompass 4 Reader
model supports this tag protocol.
Error if tag protocol is
unsupported.
Serial number set
S...S = ASCII string
(maximum length of 6
characters)
695S...S Done
Software flow control enable 6141 Done
Stop bit use one 1010 Done
Stop bit use two 1011 Done
Synchronization hold off time
disable
64900 Done
Synchronization hold-off time set
NN = 01 to 0A, where 01 = 1 ms
and 0A = 10 ms.
649NN Done
Table D-3 Encompass 4 Reader Commands Listed Alphabetically (continued)
Command Name Code Reader Message
To Next Page
Loading...
