How to adjust TransCore Encompass 4 Reader when there is a hollow spot in the center of the read zone?
The angle of the Encompass 4 Reader or external antenna may need adjustment. Slightly tilt the Encompass 4 Reader or external antenna to a different angle to change either the length or width of the read zone. Check the range control adjustment.
Covers critical criteria for optimal tag readability and reader placement.
Lists and describes various TransCore tag types compatible with the Encompass 4 Reader.
Provides step-by-step instructions for applying eGo Plus Sticker Tags to vehicle windshields.
Offers guidance on installing ATA tags on vehicle license plate areas.
Outlines the key tasks involved in installing the Encompass 4 Reader system.
Explains procedures for testing reader power and tag read capability before permanent installation.
Covers procedures for mounting the reader on poles, walls, or flat surfaces.
Details how to connect the reader to a PC via RS-232, RS-422, or Wiegand interfaces.
Details ECP for ensuring data integrity, including CRC and sequence numbers.
Lists and explains failure conditions that the reader addresses, such as illegal sequence numbers.
Provides instructions for using terminal emulation software to configure reader parameters.
Guides on adjusting the read zone by modifying RF power or sensitivity.
Lists common error messages and their corresponding corrective actions.
Provides a table of common symptoms and their suggested remedies for issues.
General| Brand | TransCore |
|---|---|
| Model | encompass 4 |
| Category | Card Reader |
| Language | English |
To Next Page
