Vacon 100 flow Applications Manual

Table 33: Start/stop setup menu
Index Parameter Min Max Unit Default ID Description
P3.2.8 Fieldbus Start Logic 0 1 0 889
0 = A rising edge is
necessary
1 = State
P3.2.9 Start Delay 0.000 60.000 s 0.000 524
P3.2.10
Remote to Local
Function
0 2 2 181
0 = Keep Run
1 = Keep Run & Refer-
ence
2 = Stop
P3.2.11 Restart Delay 0.0 20.0 min 0.0 15555 0 = Not used
* = The selection of the application with parameter P1.2 Application gives the default value.
See the default values in Chapter 12.1 The default values of parameters in the different
applications.
VACON · 132 PARAMETERS MENU
5
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/

Vacon 100 flow Specifications

General

Protection class	IP20
Communication interface	RS-485
Operating temperature	-10°C to +50°C
Storage temperature	-40°C to +70°C
Ambient temperature	-10°C to +40°C
Control method	Sensorless vector control
Communication protocols	CANopen
Approvals	CE, UL
I/O	2 analog inputs
Protection features	Overcurrent, overvoltage, undervoltage, overtemperature
Frequency range	0 Hz to 400 Hz
Humidity	5% to 95%, non-condensing
Voltage range	208-240 V