Vacon 100 flow Applications Manual

•
0 = kWh
•
1 = MWh
•
2 = GWh
•
3 = TWh
•
4 = PWh
Example: If you receive the value 4500 from ID2291, the value 42 from ID2303, and the value 0
from ID2305, the result is 45.00 kWh.
10.22.6 ENERGY TRIP COUNTER
The energy trip counter counts the quantity of energy that the drive gets from the supply
network. The counter is in the submenu Trip counters. You can reset the counter with the PC,
the control panel, or the fieldbus. To read the value of the counter through fieldbus, use
these ID numbers.
ID 2296 Energy Trip Counter
The value has always 4 digits. The format and the unit of the counter change to agree with
the energy trip counter value. See the example below. You can monitor the energy counter
format and unit with ID2307 Energy Trip Counter Format and ID2309 Energy trip Counter
unit.
Example:
•
0.001 kWh
•
0.010 kWh
•
0.100 kWh
•
1.000 kWh
•
10.00 kWh
•
100.0 kWh
•
1.000 MWh
•
10.00 MWh
•
100.0 MWh
•
1.000 GWh
•
etc...
ID2307 Energy Trip Counter Format
The energy trip counter format gives the position of the decimal point in the value of the
Energy Trip Counter.
•
40 = 4 digits, 0 fractional digits
•
41 = 4 digits, 1 fractional digit
•
42 = 4 digits, 2 fractional digits
•
43 = 4 digits, 3 fractional digits
Example:
•
0.001 kWh (Format = 43)
•
100.0 kWh (Format = 41)
•
10.00 MWh (Format = 42)
VACON · 358 PARAMETER DESCRIPTIONS
10
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/

Vacon 100 flow Specifications

General

Protection class	IP20
Communication interface	RS-485
Operating temperature	-10°C to +50°C
Storage temperature	-40°C to +70°C
Ambient temperature	-10°C to +40°C
Control method	Sensorless vector control
Communication protocols	CANopen
Approvals	CE, UL
I/O	2 analog inputs
Protection features	Overcurrent, overvoltage, undervoltage, overtemperature
Frequency range	0 Hz to 400 Hz
Humidity	5% to 95%, non-condensing
Voltage range	208-240 V