P3.10.12 AUTORESET: EXTERNAL FAULT (ID 726)
Use this parameter to enable the automatic reset after an external fault.
P3.10.13 AUTORESET: UNDERLOAD FAULT (ID 738)
Use this parameter to enable the automatic reset after an underload fault.
P3.10.14 AUTORESET: PID SUPERVISION FAULT (ID 776)
Use this parameter to enable the automatic reset after a PID supervision fault.
P3.10.15 AUTORESET: EXT PID SUPERVISION FAULT (ID 777)
Use this parameter to enable the automatic reset after an external PID supervision fault.
10.12 APPLICATION SETTINGS
P3.11.1 PASSWORD (ID 1806)
Use this parameter to set the administrator password.
P3.11.2 C/F SELECTION (ID 1197)
Use this parameter to set the temperature measuring unit.
The system shows all the temperature-related parameters and monitoring values in the set
unit.
P3.11.3 KW/HP SELECTION (ID 1198)
Use this parameter to set the power measuring unit.
The system shows all the power-related parameters and monitoring values in the set unit.
3.11.4 MULTIMONITOR VIEW (ID 1196)
Use this parameter to set the division of the display of the control panel into sections in the
multimonitor view.
10.13 TIMER FUNCTIONS
The timer functions make it possible for the internal RTC (Real Time Clock) to control
functions. All the functions that can be controlled with a digital input, can also be controlled
with the RTC, with time channels 1-3. It is not necessary to have an external PLC to control a
digital input. You can program the closed and opened intervals of the input internally.
To get the best results of the timer functions, install a battery, and make the settings of the
Real Time Clock carefully in the Start-up wizard. The battery is available as an option.
VACON · 298 PARAMETER DESCRIPTIONS
10
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
To Next Page
Loading...
Need help?
General
