P3.5.1.54 MULTI-SETPOINT SELECTION 0 (ID 15576)
Use this parameter to select the digital input signal that is used as a selector for the PID
Multi-setpoint function.
P3.5.1.55 MULTI-SETPOINT SELECTION 1 (ID 15577)
Use this parameter to select the digital input signal that is used as a selector for the PID
Multi-setpoint function.
P3.5.1.56 MULTI-SETPOINT SELECTION 2 (ID 15578)
Use this parameter to select the digital input signal that is used as a selector for the PID
Multi-setpoint function.
P3.5.1.57 MULTI-SETPOINT SELECTION 3 (ID 15579)
Use this parameter to select the digital input signal that is used as a selector for the PID
Multi-setpoint function.
P3.5.1.58 FLOW SWITCH (ID 15590)
Use this parameter to select the digital input signal that is the feedback signal from the Flow
Switch.
P3.5.1.59 AHF OVER TEMPERATURE (ID 15513)
Use this parameter to set the digital input signal that activates AHF Over Temperature (fault
ID 1118).
10.6.4 ANALOGUE INPUTS
P3.5.2.1.1 AI1 SIGNAL SELECTION (ID 377)
Use this parameter to connect the AI signal to the analogue input of your choice.
This parameter is programmable. See Table 120 Default functions of the programmable digital
and analogue inputs.
P3.5.2.1.2 AI1 SIGNAL FILTER TIME (ID 378)
Use this parameter to filter out disturbances in the analogue input signal.
To activate this parameter, enter a value greater than 0.
NOTE!
A long filter time makes the regulation response slow.
PARAMETER DESCRIPTIONS VACON · 267
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
10
To Next Page
Loading...
Need help?
General
