Vacon 100 flow Applications Manual

The selection of the application with parameter P1.2 Application gives the default value.
P3.5.1.44 PUMP 3 INTERLOCK (ID 428)
Use this parameter to select the digital input signal that is used as interlock signal for the
Multi-pump system.
The selection of the application with parameter P1.2 Application gives the default value.
P3.5.1.45 PUMP 4 INTERLOCK (ID 429)
Use this parameter to select the digital input signal that is used as interlock signal for the
Multi-pump system.
P3.5.1.46 PUMP 5 INTERLOCK (ID 430)
Use this parameter to select the digital input signal that is used as interlock signal for the
Multi-pump system.
P3.5.1.47 PUMP 6 INTERLOCK (ID 486)
Use this parameter to select the digital input signal that is used as interlock signal for the
Multi-pump system.
P3.5.1.48 PUMP 7 INTERLOCK (ID 487)
Use this parameter to select the digital input signal that is used as interlock signal for the
Multi-pump system.
P3.5.1.49 PUMP 8 INTERLOCK (ID 488)
Use this parameter to select the digital input signal that is used as interlock signal for the
Multi-pump system.
P3.5.1.52 RESET KWH TRIP COUNTER (ID 1053)
Use this parameter to select the digital input signal that resets the kWh Trip Counter.
P3.5.1.53 PARAMETER SET 1/2 SELECTION (ID 496)
The parameter gives the digital input which is used to select Parameter Set 1 or Set 2. The
function is enabled if other slots than DigIN Slot0 are selected to this parameter. The
selection of the parameter set can be made and the set changes only when the drive is
stopped.
•
Contact Open = Parameter Set 1 is set as the active set
•
Contact Closed = Parameter Set 2 is set as the active set
NOTE!
Parameter values are stored to Set 1 and Set 2 with parameters B6.5.4 Save to Set
1 and B6.5.4 Save to Set 2. You can use these parameters with the keypad or the PC
tool VACON
®
Live.
VACON · 266 PARAMETER DESCRIPTIONS
10
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/

Vacon 100 flow Specifications

General

Protection class	IP20
Communication interface	RS-485
Operating temperature	-10°C to +50°C
Storage temperature	-40°C to +70°C
Ambient temperature	-10°C to +40°C
Control method	Sensorless vector control
Communication protocols	CANopen
Approvals	CE, UL
I/O	2 analog inputs
Protection features	Overcurrent, overvoltage, undervoltage, overtemperature
Frequency range	0 Hz to 400 Hz
Humidity	5% to 95%, non-condensing
Voltage range	208-240 V