Table 121: The output signals through RO1
Selection
number
Selection name Description
42
Block Out.7 The output of the programmable Block 7.See parameter
menu M3.19 Block Programming.
43
Block Out.8 The output of the programmable Block 8. See parameter
menu M3.19 Block Programming.
44
Block Out.9 The output of the programmable Block 9. See parameter
menu M3.19 Block Programming.
45
Block Out.10 The output of the programmable Block 10. See parameter
menu M3.19 Block Programming.
46 Jockey pump control The control signal for the external jockey pump.
47 Priming pump control The control signal for the external priming pump.
48 Auto-cleaning active The Pump auto-cleaning function is activated.
49 Multi-pump K1 control The contactor control for the Multi-pump function.
50 Multi-pump K2 control The contactor control for the Multi-pump function.
51 Multi-pump K3 control The contactor control for the Multi-pump function.
52 Multi-pump K4 control The contactor control for the Multi-pump function.
53 Multi-pump K5 control The contactor control for the Multi-pump function.
54 Multi-pump K6 control The contactor control for the Multi-pump function.
55 Multi-pump K7 control The contactor control for the Multi-pump function.
56 Multi-pump K8 control The contactor control for the Multi-pump function.
69 Selected parameter set
Shows the active parameter set:
OPEN = Parameter set 1 active
CLOSED = Parameter set 2 active
72 AHF Capacitor Disconnection
73
AHF Capacitor Disconnection
Inverted
74 Run indication
P3.5.3.2.2 RO1 ON DELAY (ID 11002)
Use this parameter to set the ON delay for the relay output.
PARAMETER DESCRIPTIONS VACON · 275
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
10
To Next Page
Loading...
Need help?
General
