Vacon 100 flow Applications Manual

Table 10: M1.34 Multi-pump (single drive)
Index Parameter Min Max Unit Default ID Description
1.34.10
SP1 Sleep Fre-
quency Limit
0.0 320.0 Hz 0.0 1016
The drive goes to
the sleep mode
when the output
frequency stays
below this limit for
longer than is
specified by
parameter Sleep
Delay.
0 = Not used
1.34.11 SP1 Sleep Delay 0 3000 s 0 1017
The minimum
quantity of time
that the frequency
stays below the
sleep level before
the drive stops.
0 = Not used
1.34.12
SP1 Wake Up
Level
Varies Varies Varies Varies 1018
The wake-up value
of the PID feedback
supervision. Wake-
up Level 1 uses the
selected process
units.
0 = Not used
1.34.13
Multi-pump
Mode
0 2 0 1785
Selects the Multi-
pump mode.
0= Single drive
1= Multifollower
2= Multimaster
1.34.14
Number of
Pumps
1 8 1 1001
Total number of
motors (pumps/
fans) used in the
Multi-pump sys-
tem.
1.34.15
Pump Interlock-
ing
0 1 1 1032
Enable/Disable
interlocks. Inter-
locks tell the sys-
tem if a motor is
connected or not.
0 = Disabled
1 = Enabled
QUICK STARTUP GUIDE VACON · 41
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
1

Vacon 100 flow Specifications

General

Protection class	IP20
Communication interface	RS-485
Operating temperature	-10°C to +50°C
Storage temperature	-40°C to +70°C
Ambient temperature	-10°C to +40°C
Control method	Sensorless vector control
Communication protocols	CANopen
Approvals	CE, UL
I/O	2 analog inputs
Protection features	Overcurrent, overvoltage, undervoltage, overtemperature
Frequency range	0 Hz to 400 Hz
Humidity	5% to 95%, non-condensing
Voltage range	208-240 V