Vacon 100 flow - Page 8

4 Monitoring menu 113
4.1 Monitor group 113
4.1.1 Multimonitor 113
4.1.2 Trend curve 114
4.1.3 Basic 117
4.1.4 I/O 119
4.1.5 Temperature inputs 119
4.1.6 Extras and advanced 120
4.1.7 Timer functions monitoring 121
4.1.8 PID controller monitoring 122
4.1.9 External PID controller monitoring 123
4.1.10 Multi-pump monitoring 123
4.1.11 Maintenance counters 125
4.1.12 Fieldbus process data monitoring 125
4.1.13 Drive customizer monitoring 126
5 Parameters menu 127
5.1 Group 3.1: Motor settings 127
5.2 Group 3.2: Start/stop setup 131
5.3 Group 3.3: References 133
5.4 Group 3.4: Ramps and brakes setup 136
5.5 Group 3.5: I/O configuration 138
5.6 Group 3.6: Fieldbus data mapping 149
5.7 Group 3.7: Prohibit frequencies 150
5.8 Group 3.8: Supervisions 151
5.9 Group 3.9: Protections 152
5.10 Group 3.10: Automatic reset 158
5.11 Group 3.11: Application settings 159
5.12 Group 3.12: Timer functions 159
5.13 Group 3.13: PID controller 162
5.14 Group 3.14: External PID controller 174
5.15 Group 3.15: Multi-pump 177
5.16 Group 3.16: Maintenance counters 180
5.17 Group 3.17: Fire mode 181
5.18 Group 3.18: Motor preheat parameters 182
5.19 Group 3.19: Drive customizer 182
5.20 Group 3.21: Pump control 183
5.21 Group 3.23: Advanced harmonic filter 186
6 Diagnostics menu 187
6.1 Active faults 187
6.2 Reset faults 187
6.3 Fault history 187
6.4 Total counters 187
6.5 Trip counters 189
6.6 Software info 190
VACON · 8 TABLE OF CONTENTS
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/