Vacon 100 flow Applications Manual

CHANGING THE CONTROL PLACE
1 Anywhere in the menu structure, push the FUNCT
button.
STOP
READY Keypad
ID: M1
Main Menu
Monitor
( 12 )
( 21 )
( 6 )
Parameters
Diagnostics
2 To make a selection of the Local/Remote, use the
arrow buttons Up and Down. Push the OK button.
STOP
READY Keypad
ID:1805
Choose action
Control page
Change direction
Local/Remote
3 To make a selection of Local or Remote, use the
arrow buttons Up and Down again. To accept the
selection, push the OK button.
STOP
READY Keypad
ID:211
Local/Remote
Remote
Local
4 If you changed Remote control place to Local, that
is, the keypad, give a keypad reference.
STOP
READY I/O
ID: M1
Main Menu
( 21 )
( 6 )
Parameters
( 12 )
Monitor
Diagnostics
After the selection, the display goes back into the same location where it was when you
pushed the FUNCT button.
VACON · 96 USER INTERFACES
3
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/

Vacon 100 flow Specifications

General

Protection class	IP20
Communication interface	RS-485
Operating temperature	-10°C to +50°C
Storage temperature	-40°C to +70°C
Ambient temperature	-10°C to +40°C
Control method	Sensorless vector control
Communication protocols	CANopen
Approvals	CE, UL
I/O	2 analog inputs
Protection features	Overcurrent, overvoltage, undervoltage, overtemperature
Frequency range	0 Hz to 400 Hz
Humidity	5% to 95%, non-condensing
Voltage range	208-240 V