2. Configure the WPA using the following details:
Description Enter a description or name to uniquely identity a WPA.
Transmitter
ID
Enter the Transmitter ID that is printed on the casing of the WPA.
Alternatively, press any button on the WPA and click the Learn button.
The Transmitter ID field is automatically populated.
Supervise You can configure the WPA to send periodic supervision signals.
Supervision is enabled on the WPA with a jumper.
For correct supervision operation, enable the supervision function on the
panel for the particular WPA. If the panel does not get a supervision signal,
it raises an alarm that is shown in the keypad and logged.
If supervision is not enabled, the WPA transmits the battery status to the
panel about every 24 hours. The message is also randomized to decrease
the chances of collision with other WPAs.
Tick the Supervise box to enable supervision for the WPA.
Test Tick the Test box if a periodic WPA test is required. The timeframe for
periodic testing is configured on the Changing wireless settings page (see
Changing wireless settings on page227).
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 214 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
