ACCESS
CONTROL
If no card assigned to the user:
l ADD CARD
l LEARN CARD
If a card assigned to the user:
l EDIT CARD
– CARD NUMBER
– CARD ATTRIBUTES
l RESET CARD
l DELETE CARD
LANGUAGE Select a language for this user that will be displayed on the system.
16.7.2.1 Access Control
One access card can be assigned to each of the users on the control panel.
To configure the access control for a user:
1. Scroll to USERS>EDIT.
2. Press OK.
3. Select the user which should be configured and press OK.
4. Scroll to ACCESS CONTROL and press OK.
The following sections provide programming steps found within the access control option of the
selected user.
Add Card manually
If the card format of the card number is known, the card can be created manually.
The site code of the card is configured for the user profile that is assigned for this user.
1. Scroll to ADD CARD.
2. Press OK.
An empty card has been added and can now be edited.
Learn Card
NOTICE: Only cards with supported card formats can be learned.
If the card number or the card format is not known, the card can be read and its information learned.
1. Scroll to LEARN CARD.
2. Press OK.
3. Select the door that the card will be presented.
4. Press OK.
NOTICE: The new card can be presented at the entry or the exit reader of the
selected door.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the keypad
© Vanderbilt 2018 136 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
