Housing
Tamper
The physical and programmed status of the expander housing tamper.
PACE Applies only to Keypads with a PACE receiver installed.
Panic Keypad panic alarm status.
Fire Keypad Fire alarm status.
Medical Keypad medical alarm status.
Code Tamper Keypad PIN tamper alarm status
Performable actions
Restore
Alerts
Click the button to restore all alerts on the panel.
Inhibit Click this button to inhibit a fault condition. The inhibit operation will disable that fault or zone for one
arming period only.
Inhibit operation is not available in Security Grade EN 50131 Grade 3.
Isolate Click this button to isolate that zone. Isolating a zone will de-activate that zone until such time as the
zone is explicitly de-isolated again. It is recommended that you exercise caution when isolating
zones as those zones will not be active every time the system is SET.
17.6.2.4 Door Controller Status
1. Select Status > Hardware > X-Bus Status.
2. Select the Door Controllers tab.
A list of detected door controllers is displayed.
Name Description
Expander ID This ID number is a unique identifier for the door controller.
Description Text description of the door controller (max. 16 characters).
Type The type of expander detected (=door controller).
S/N The serial number of the door controller.
Version The firmware version of the door controller.
Comms The status of the door controller (online or offline).
Status The status of the door controller (OK, Fault).
PSU Specifies if the door controller has a PSU.
Performable actions
Refresh Click the Refresh button to update the status of the system alerts.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 186 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
