Performable actions
The following actions are only possible if a connection has been established.
Restore All Alerts Restores all active alerts on the panel. These alerts messages are displayed in
red text opposite the relevant item.
Refresh Updates any changes in panel status. You must refresh the status page to
display the actual panel status at any particular moment.
FullEngineer/SoftEngineer To toggle between Soft- and Full Engineer modes. Full Engineer mode disables
alarms and prevents reporting of events to a central station.
17.6.2 X-Bus Status
1. Select Status > Hardware > X-Bus Status.
The following page with the status of the different X-Bus devices is displayed. All detected
expanders are listed as default.
2. Select one of the following tabs.
- Expanders (for programming expanders, see Expanders on page238).
- Keypads (for programming keypads, see Keypads on page244).
- Door controllers (for programming door controllers, see Door Controllers on page249).
3. Click any of the keypad/expander/door controller identifying parameters (ID, description, type,
serial number) to displayed further status details.
17.6.2.1 Expander Status
1. Select Status > Hardware > X-Bus Status.
2. Select the Expanders tab.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 180 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
