DETECT RF
JAM.
Enable or disable the RF JAM.
RF FOB SOS Disable the RFFOB SOS or enable PANIC, PANIC SILENT, USER MEDIC, USER
HOLDUP, or RF OUTPUT.
WPA TEST
SCHED.
Enter a maximum period (in days) between WPA tests. Max is 365 days.
PREVENT SET
TIME
Enter a time in minutes after which, if the sensor or WPA fails to report, setting is prevented
for the area where the wireless zone is. Max is 720 minutes.
DEVICE LOST
TIME
Enter the number of minutes after which the wireless device is reported as lost if it fails to
report within this time frame. (Min is 20 and max is 720 minutes)
WIRELESS
LOST
Enable or disable wireless lost.
2 WAY
WIRELESS
Enable or disable two-way wireless depending on the transceiver you are using.
Enable two-way wireless if you are using SPCW120 Wireless Transceiver. Disable two-way
wireless if you are using SiWay RF Kit (SPCW110, 111, 112, 114 ).
1
A WPA is compatible with SiWay RF Kit (SPCW110, 111, 112, 114 ) only.
16.9.2 One-way wireless
The following devices can be enrolled on a one-way wireless transceiver:
l Wireless sensors
l Wireless Personal Alarm (WPA)
l IPAW6-10
l IRCW6-11
You must disable two-way wireless before enrolling these devices.
To disable two-way wireless:
1. Scroll to WIRELESS and press OK.
2. Scroll to 2 WAY WIRELESS.
3. Select DISABLE.
16.9.2.1 Wireless Sensors
Add Sensors
To add a wireless sensor device:
1. Scroll to WIRELESS > SENSORS > ADD and press OK.
A menu of enrolment options opens. Options are:
l ENROL
l TAMPER ENROL
l ACTIVATE ENROL
2. Scroll to your desired option and press OK.
The display flashes the text ENROL DEVICE.
3. Activate the wireless device by inserting the battery/batteries to allow the keypad receiver to detect
the wireless transmission of the device.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the keypad
© Vanderbilt 2018 141 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
