Vanderbilt SPC42 Series - Compliance with NF and A2 P Approvals

Directives and standards
3
EU directives
29
Vanderbilt
Installation & Configuration Manual
A6V10276959
01.05.2016
 Hardware Fault reporting — in Options, you must select the Enabled +
Reporting (10s) option from the Watchdog Output Mode drop-down list.
Note: Hardware faults are not reported if the Engineer is logged in to the
system.
Hardware
VDS compliance requires the following:
 A G5 housing with Front tamper implemented as a minimum requirement.
 Keypads do not show status information if the system is armed.
 The number of supported zones is as follows:
– 512 zones in ring configuration
– 128 zones per X-Bus in multi-drop (spur) configuration
 The following end of line resistance combinations do not comply with VdS
standards:
– 1k, 470 ohm
– 1k, 1k, 6k6 ohm
3.1.7 Compliance with NF and A2P approvals
Address of Certifying Body
CNPP Cert
Pôle Européen de Sécurité - Vernon
Route de la Chapelle Réanville
CD 64 - CS 22265
F-27950 SAINT MARCEL
www.cnpp.com
AFNOR Certification
11 rue François de Pressensé
93571 Saint Denis La Plaine Cedex
www.marque-nf.com
To comply with NF & A2P installation regulations, this enclosure must be sealed
by affixing the accompanying Tamper Label after installation.