Mounting the Wall Fixing Plate
1. Mount the SPC in the appropriate position on the wall using all three fixings (see item 1 below).
2. Draw a line around the inside of the back tamper cut out (see item 2 above) to provide a guide for
the wall plate on the fixing wall. Remove the housing from the wall.
3. Place the wall plate (see item 1 below) on the wall centering it precisely around the rectangle
previously drawn (see item 2 below).
4. Ensure all four flanges on the wall plate are flush with the wall.
5. Mark the four fixings on the wall plate.
6. Drill and use suitable screws (max. 4mm) for the wall substrate.
7. Fit the wall plate to the wall.
Fitting the Back Tamper Switch
1. Insert the tamper switch (see item 2 below) into the back of the housing so that the plunger faces
outwards (see item 1 below).
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Mounting system equipment
© Vanderbilt 2018 47 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
