Note: The sensor will not show in the Enrolled Sensors List until the Enrol New Sensor button is
clicked.
4. When the sensor is found, click the Add button.
5. Set the sensor attributes.
6. The sensor appears in the Enrolled Sensors List.
Programmable attributes for wireless sensors
Description Text description of the sensor.
Sensor Type The type of wireless sensor detected (e.g. magnetic contact, PIR).
Zone The zone number to which the sensor has been enrolled.
Zone Type The type of zone (e.g. Alarm, Entry/Exit).
Area Areas to which the zone is assigned.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 221 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
