Devices compatible with a two-way transceiver
Wireless sensors WPIR Wireless 12m PIR detector with pet immunity option
WPIR-CRT Wireless curtain PIR detector
WMAG Wireless magnetic contact (slim)
WMAG-I Magnetic contact with additional input
WRMT Remote control FOB with 4 button control
WPAN Wireless personal alarm button
For instructional videos on wireless devices and transceivers please go to
http://van.fyi?Link=Wireless_devices
16.9.1 Select a wireless programming option
To select a wireless programming option:
1. Scroll to WIRELESS and press OK.
2. Scroll to the desired programming option. Options are described in the following table:
SENSORS It may be necessary to change the type of sensor enrolled on the system if the sensor type
was incorrectly identified in the enrolment process.
The following options are available for sensors:
l ADD
See Wireless Sensors on page145.
l EDIT (Change zone assignment)
See Edit Sensors (Zone Assignment) on page146
l REMOVE
Select the device or sensor to be deleted.
WPA
1
Add, edit or remove a WPA (Wireless Personal Alarm).
l ADD
See Add a WPA on page142.
l EDIT
See Edit a WPA on page142.
l REMOVE
Select the WPA to be deleted.
EXTERNAL
ANTENNA
Enable or disable the external antenna.
SUPERVISION Enable or disable tamper supervision.
FILTER LOW
SIGNL
Enable or disable the filter low signal (RF strengths 0 and 1).
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the keypad
© Vanderbilt 2018 140 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
