17 Engineer programming via the browser
Engineer programming options on the SPC panel can be accessed via any standard web browser on a PC
and is PIN protected.
You can access Engineer Programming via the browser by entering the default Engineer PIN (1111). For
more details, see Engineer PINs on page106.
This web server provides access to the complete set of programming features used to install and configure
the SPC system.
This programming option should only be provided to authorized installers of the SPC system.
Engineer Programming features on the SPC are divided into the following categories:
Soft Engineer Features
These features can be programmed without requiring the alarm system to be deactivated; they are
accessible directly upon entering Engineer mode.
Full Engineer Features
These features require the alarm system to be deactivated before programming can commence; these
features are accessible under the Full Engineer menu.
NOTICE: If ‘Engineer Exit’ option is enabled in System Options, the engineer is allowed leave Full
Engineer mode with alerts active but must acknowledge all alerts listed on the keypad or in the
browser before switching from Full Engineer mode to Soft Engineer mode.
The web server on SPC controller can be accessed using either the Ethernet or USB interface.
If programming with a browser interface, click Save when making changes.
Click Refresh to view the current programming values on a web page.
17.1 System Information
Click the ? icon to view the Help menu which provides up-to-date information about the panel and the
functionality that is currently licensed on the system.
17.2 Ethernet interface
© Vanderbilt 2018 172 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
