8. To apply an event profile to an area, select the area under Area Filter.
9. Click Save and Back. The new profile displays in the Event Profiles table.
You can view a list of all event exceptions for an event profile under Event Exceptions on the
Event Profiles page.
You cannot delete the Default Event Profile, the Default Portal Event Profile or an event profile
that is assigned to an ATS. If you try to delete an event profile that is in use, you will get an error.
Event Exception Definition
Event exceptions allow you to change the following settings for a range of addresses within an event:
l Report Event
l SIA Code
l CID Code
l Event Address (for example, Zone IDs, Area IDs, User IDs)
For example, in the Filter Group Intruder Alarms you could define an event exception for a range of
Zone IDs in the Burglary Alarm (BA) event as follows:
l Do not report BA events for Zone ID 1–9
l Remap the SIA Code from BA to YZ
l Remap the CID from 130/1 to 230/1
l Remap the Zone ID 1–9 to Zone ID 101–109
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 320 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
