When you export an ATS, the SPT Account Code changes to 0. This prevents an ATS being exported
and then imported and replicating an existing ATS.
17.11.2.6 Configuring Event Profiles
The event profile defines which events are transmitted on an ATS, the reporting status for an event and
event exceptions. Event exceptions allow you to remap default values for events to customised values.
For more information, see Event Exception Definition on the facing page.
To see a list of all events, go to Communications > FlexC > Event Profiles. Click the Edit icon for
an event profile. Scroll to the end of the page and click Show Complete Event Table.
To quickly create a new event profile, go to Communications > FlexC > Event Profiles. In the
Event Profiles table, select an event profile and click the Edit icon. Scroll to the bottom of the page
and click Replicate. You can now make the changes you require.
1. To configure FlexC event profiles step by step, go to Communications > FlexC > Event Profiles.
2. Click Add. The Event Profiles page displays.
3. Enter a Name to identify the event profile.
4. Select the event filter groups to report for this profile by ticking the Report Event checkboxes.
5. To prevent reporting of certain events or addresses within an event, select the event from the
corresponding Add Event Exception dropdown list.
6. Click Add to view the Event Exception Definition page. See Event Exception Definition on the
facing page.
7. Click Back to return to the Event Profiles page.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 319 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
