Edit a sensor
To edit a sensor:
1. Click the Edit button beside the sensor you want to edit.
2. Edit the sensor attributes.
3. Click Save to save your changes.
17.9.2.2 Set additional two-way wireless attributes
Depending on the sensor type, additional two-way wireless attributes can be configured by clicking the
Edit button beside the sensor in the Enrolled Sensors List.
PIR
To program the attributes for a PIR:
1. Select Configuration > Hardware > Wireless Settings.
2. Click the Edit button beside the desired PIR.
Programmable attributes for PIR
Sensor The number of the sensor as enrolled on the system (1 = first, 2 = second, etc).
Description Text description of the sensor.
Sensor Type The type of wireless sensor detected (e.g. magnetic contact, PIR).
Zone The zone number to which the sensor has been enrolled.
Zone Type The type of zone (e.g. Alarm, Entry/Exit).
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 222 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
