5. Present the card at a card reader at the selected door.
The information for the new card is learned.
Edit Card
If an access card is already assigned to a user it can be changed via the keypad:
1. Scroll to EDIT CARD.
2. Press OK.
3. Edit the desired user setting shown in the table in Access Control below.
4. Press BACK to exit.
Access Control
Attribute Description
Card
Number
Enter card number. Enter 0 to unassign this card.
Void Card Check to temporarily disable this card.
Extended
Time
Extend door timers when this card is present.
PIN
bypass
Access a door without PIN on a door with PIN reader.
Priority Priority cards are stored locally in the door controllers and will grant access in case of a technical fault
where the door controller cannot communicate with the control panel.
The maximum number of priority users is:
l SPC4xxx – all users
l SPC5xxx – 512
l SPC6xxx – 512
Escort The escort feature enforces privileged card holders to escort other card holders through specific doors.
If this feature is enabled on a door, a card with the “escort” right has to be presented first, to allow other
cardholders without this right to open the door. The time period in which cardholders are able to
present their cards after a card with escort right was presented, can be configured per door.
Custodian The custodian feature enforces a card holder with custodian privilege to always be inside a room (door
group) when other card holders are inside.
The custodian must be the first to enter the room. Only if a custodian is in the room other cardholders
are allowed to enter. The cardholder with the custodian right will not be allowed to exit until all non-
custodian cards left the room.
Identifies this card holder as a custodian. The user with the custodian attribute has to be the first who
enters a door group which requires a custodian card holder and has to be the last that is leaving this
door group.
Delete Card
If an access card is no longer needed it can be deleted via the keypad.
1. Scroll to DELETE CARD.
2. Press OK.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the keypad
© Vanderbilt 2018 137 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
