To configure the serial ports:
l Select Communications > Communications > Serial Ports.
The following page will be displayed:
The settings displayed will depend on the type of connection that the ports are used for. The
settings are described in the following sections.
17.11.2 FlexC
®
The SPC Flexible Secure Communications Protocol (FlexC) enables communications for an Internet
Protocol (IP) based single or multiple path Alarm Transmission System (ATS). An ATS is a reliable
communications link between a Supervised Premises Transceiver (SPT, for example, Ethernet
integrated onto the SPC panel) and a Receiving Centre Transceiver (RCT, for example, SPC Com XT
or the SPC Connect server, www.spcconnect.com). A FlexC ATS consists of a primary Alarm
Transmission Path (ATP) and up to nine backup Alarm Transmission Paths (ATPs). It enables:
l Two-way transfer of data between the SPT, for example the SPC panel over Ethernet, and the
RCT, for example, the SPC Com XT server or the SPC Connect server, www.spcconnect.com.
l Communication monitoring of a complete ATS and individual ATPs.
SPC intrusion panels support FlexC over IP with any of the following interfaces:
l Ethernet
l GSM modem with GPRS enabled
l PSTN modem
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 304 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
