To Next Page

To Previous Page

4. Configure the SMS details as follows:

SMS ID System generated ID.

User Select a new user for this SMS ID if required.

SMS

Number

Enter the number to which the SMS will be sent (requires three-digit country code

prefix).

Note: Engineer SMS number can deleted by resetting it 0. User SMS numbers

cannot be deleted.

SMS

Events

Select the panel events which the user or engineer will receive via SMS.

SMS

Control

Select the operations that the user or engineer can perform remotely on the panel

through SMS. See SMS Commands below.

NOTICE: HOLDUP alarm events are not transmitted via SMS.

If the phone line is connected to the PSTN network via a PBX, the appropriate line access digit

should be inserted before the called party number. Ensure that Calling Line Identity (CLI) is

enabled on the line selected to make the call to the SMS network. Consult the PBX administrator

for details.

17.8.4 SMS Commands

When the SMS setup and configuration is complete, SMS features may be activated. Commands,

depending on SMS configuration, are sent using a PIN or caller ID. The type of PIN depends on what is

set for SMS Authentication.

The table below provides all available SMS commands. Subsequent action and response are also

provided.

SMS Commands are sent as texts to the phone number of the SIM card on the controller.

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser

11.2018

Vanderbilt SPC42 Series User Manual

Questions and Answers: