When the device has been detected the text FOUND SENSOR is displayed on the keypad. The
device ID, TYPE, and SIGNAL information is displayed beneath FOUND SENSOR.
4. Press OK.
A prompt to select the area is displayed.
5. Scroll to the desired option and press OK.
A prompt to select a zone type is displayed.
6. Scroll to the required zone type and press OK.
Edit Sensors (Zone Assignment)
It may be necessary to change the zone assignment of a sensor enrolled on the system.
To change the zone assignment of a wireless detector:
1. Scroll to EDIT and press OK.
2. Scroll to the sensor to be changed and press OK.
3. Scroll to ZONE and press OK.
4. Scroll to the appropriate zone number (only unoccupied zone numbers are displayed) and press
OK.
16.9.2.2 WPA
l You can only configure a WPA or check WPA status on the keypad if there is a wireless
module fitted on the panel or any of the panel expanders.
l A WPA is compatible with SiWay RF Kit (SPCW110, 111, 112, 114 ) only.
A WPA is not assigned to a user. Usually, a WPA is shared by several people, for example, security
guards working in shifts. Alternatively a WPA may be permanently attached to a surface such as under
a desk or behind a till.
You can connect up to 128 WPAs per SPC panel.
Add a WPA
To add a WPA with the keypad:
1. Select WIRELESS > WPA > ADD.
2. Select MANUALLY to manually enter a WPA ID.
Alternatively, the ID can be entered automatically by the panel by selecting the LEARN WPA
option. Press any button on the WPA when the ACTIVATE WPA message is displayed, for the
panel to identify the WPA. The panel will not accept a WPA if the WPA ID is a duplicate of a
currently configured WPA.
3. Exit the ADD menu.
4. Select the EDIT menu to configure the WPA.
Edit a WPA
To edit a WPA, select WIRELESS > WPA > EDIT and edit the relevant fields.
Editable fields for WPA
DESCRIPTION Enter a description to uniquely identify the WPA.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the keypad
© Vanderbilt 2018 142 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
