These settings enable a report to be sent to the Control Centre or nominated personnel if the panel is
Set or Unset outside scheduled calendar times.
Early to
Set
Enables a report to be sent if the panel is manually Fullset before a scheduled Set and before the
number of minutes entered in the Timer field.
Late to
Set
Enables a report to be sent if the panel is manually Fullset after a scheduled Set and after the
number of minutes entered in the Timer field.
Early to
Unset
Enables a report to be sent if the panel is manually Unset before a scheduled Unset and before the
number of minutes entered in the Timer field.
Late to
Unset
Enables a report to be sent if the panel is manually Unset before a scheduled Unset and before the
number of minutes entered in the Timer field.
Reporting is done via SMS or to the ARC via SIA and Contact ID. An event is also stored in the system
log.
Only events configured for late or early reporting for the area will be reported.
Event reporting must also be enabled for an ARC or SMS, as described in the following sections.
Enabling Reporting of Unusual Setting/Unsetting for an ARC
To configure event reporting for an ARC configured to communicate over SIA or CID, select
Communications > Reporting > Analog ARC > Edit >Filter to display the Event Filter page for an
ARC.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 274 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
