16.24 Installer Text
This setting allows the engineer to enter system information and engineer contact information.
1. Scroll to INSTALLER TEXT and press SELECT.
2. Scroll to the desired programming option:
SYSTEM NAME Used to help identify the system; use a clear and descriptive name for
the installation.
SYSTEM ID Used to help identify the installation when connected to a central station
(max. 10 digits).
INSTALLER
NAME
Used for contact purposes.
INSTALLER
PHONE
Used for contact purposes.
DISP.
INSTALLER
Setting to display installer details can during the idle state.
The installer contact details programmed in these menu options should also be entered on the
keypad pull-down label on completion of the installation.
16.25 Door Control
This option allows you to control all the doors of the system.
1. Scroll to DOOR CONTROL and press SELECT.
2. Select the door which should be controlled and press SELECT.
3. Select one of the door states listed below as new door state and press SELECT.
NORMAL The door is in normal operation mode. A card with the corresponding
access rights is needed to open the door.
MOMENTARY The door is opened only for a timed interval to allow access.
LOCKED The door is locked. The door remains closed even if a card with the
corresponding access rights is presented.
UNLOCKED The door is unlocked.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the keypad
© Vanderbilt 2018 170 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
