16.26 SPC Connect
Add an SPC Connect ATS to set up a connection between a panel and the SPC Connect website
https://www.spcconnect.com. This enables a panel user to register and access their panel remotely using
the SPC Connect website. If SPC Connect is not enabled during the start up wizard sequence, you can
use this menu to add an SPC Connect ATS. If SPC Connect was enabled during start up, this menu
shows the Registration ID for a panel.
ADD If SPC CONNECT was disabled during the start up wizard, the ADD menu displays. Select
ADD to create an SPC Connect ATS. This allows a panel user to register their panel and
access their panel remotely using the SPC Connect website, https://www.spcconnect.com
REGISTRATION
ID
If SPC CONNECT was enabled during the start up wizard, the panel registration ID displays.
Provide this information to an end user to allow them to register their panel with the SPC
Connect website, https://www.spcconnect.com, for remote access to their panel.
COMPANY ID For future use.
DELETE To remove an SPC Connect ATS from a panel, select DELETE.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the keypad
© Vanderbilt 2018 171 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
