1. Change the PIN as follows:
Old PIN Enter the existing Engineer PIN code. (Numeric digits only)
New PIN Enter the new Engineer PIN code. (Numeric digits only)
Confirm New PIN Re-enter the New Engineer PIN code.
2. Click the Change PIN button to activate the new PIN.
The minimum number of digits required for the code depends on the security
setting of the system or on the selected length of the PIN Digits in the menu
Panel Settings > System Settings > Options.
3. Change the Web password to a more secure password for accessing the Web browser.
New Password Enter the new web access password (alphabetic characters A-Z,
numeric digits 0-9).
Confirm New
Password
Re-enter the new web access password.
4. Click the Change Password button to activate the new password.
The password is case sensitive – ensure that you enter the correct upper or lower case alphabetic
characters in your new password.
17.9 Wireless
Wireless sensor detection (868MHz) on the SPC panel is provided by wireless modules. There are two
types of wireless modules: one-way SiWay RF Kit (SPCW110, 111, 112, 114 ) and two-way SPCW120
Wireless Transceiver. The SiWay RF Kit is fitted in the controller, on the keypad, or by installing a wireless
expander. The SPC two-way wireless module is fitted into modem slot 2 of the control panel. See the table
below for information on which devices can be enrolled with each type of transceiver.
For CE regulatory compliance, the SPCW120 product can only be fitted to the following products:
l SPC5330.320-L1
l SPC6330.320-L1
l SPC4320.320-L1
l SPC5320.320-L1
l SPC5350.320-L1
l SPC6350.320-L1
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 209 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
