EasyManuals Logo

Vanderbilt SPC42 Series User Manual

Vanderbilt SPC42 Series
402 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #332 background imageLoading...
Page #332 background image
* EDP dial-up over PSTN is not supported in this release.
See also
Configuring SMS on page203
Editing Event Filter Settings
1. Select Communications > Reporting > EDP > Edit > Filter.
The following page will be displayed.
2. Configure the fields as described in the table below.
Check any of the following boxes if you want to initiate a remote call to an EDP Receiver to
notify it of the particular event.
Alarms Alarms are activated.
Alarm
Restores
System alarms are restored.
Confirmed
Alarms
Alarms confirmed by multiple zones
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 332 A6V10276959-d
11.2018

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Vanderbilt SPC42 Series and is the answer not in the manual?

Vanderbilt SPC42 Series Specifications

General IconGeneral
BrandVanderbilt
ModelSPC42 Series
CategoryPower Supply
LanguageEnglish

Related product manuals