17.6.7 System alerts
1. Select Status > System Alerts.
See tables below for further information.
Alert Description of the system alert.
Input The actual state of the alert that was detected on the panel (OK, Fault).
Status The programmed status of the system alert, that is, whether the alert has been isolated or inhibited. A
status value of OK is displayed if the alert condition has not been disabled in any way.
Performable actions
Refresh Click this button to update the status of the system alerts.
Restore Click this button to restore an alert on the panel
Inhibit Click this button to inhibit a fault condition. The inhibit operation will disable that fault or zone for one
arming period only.
Inhibit operation is not available in Security EN 50131 Grade 3.
Isolate Click this button to isolate the zone. Isolating a zone will de-activate that zone until such time as the
zone is explicitly de-isolated again. It is recommended that you exercise caution when isolating
zones as those zones will not be active every time the system is SET.
17.7 Logs
This section covers:
17.7.1 System Log 194
17.7.2 Access Log 195
17.7.3 ALARM LOG 195
17.7.1 System Log
This log displays all the system events of the SPC system.
1. Select Log > System Log > System Log.
2. Create a text file of the log by clicking Text File.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 194 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
