2. Complete the fields in the table below.
ATS Installation ID The ID of the ATS Installation (1–999999999).
Company ID For future use.
Company Name Name of the company.
ATS Installation Address The address of the ATS installation.
GPS Coordinates The GPS coordinates of the installation.
ATS Installer Name The name of the installer of the ATS.
Installer Phone Number 1 The phone number of the installer of the ATS.
Installer Phone Number 2 The phone number of the installer of the ATS.
Notes Any additional information for the RCT.
3. Click Save.
17.11.2.4 Configuring an SPC Connect ATS
The Add SPC Connect ATS functionality opens a communication between the panel (SPT) and the SPC
Connect server (RCT), www.spcconnect.com. Using the generated SPC Connect ATS Registration ID, a
panel user can register a user account and panel with the SPC Connect website to access their panel
remotely.
1. To configure an SPC Connect ATS, go to Communications > FlexC > FlexC ATS.
2. On the ATS Configuration page, click Add SPC Connect to open a communication path with the
SPC Connect server.
An SPC Connect ATS is added to the Event Sequence Table with the following attributes:
l SPC Connect ATS Registration ID
l Default ATP over Ethernet. For information on ATP fields, see Add ATP to FlexC RCT on
page309.
l Default Events Profile for SPC Connect
l Default Commands Profile for SPC Connect
l Default RCT URL is www.spcconnect.com
l The SPT Account Code for the ATP is populated.
l Make a note of the SPC Connect ATS Registration ID and provide this to the customer along
with the SPCConnect System User Guide.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 317 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
