and Remap
Event Address
to
Enter the new range of addresses, for example, if you are remapping Zone ID
1 - 9 to Zone ID 101 - 109, enter 101 and 109.
2. Click Save.
3. Click Back to return to the Event Profiles page.
The name of each exception displays in the Event Exceptions table at the bottom of the page.
The table shows the settings for the fields Report Event, Filter Exception, Event Code
(SIA/CID) and Remap Exception for the event.
4. Click the Edit icon to make changes or the Delete icon to remove an Event Exception.
5. To apply the event profile to an area, select the area checkbox.
6. Click Save to save the event profile.
7. Click Back to view the profile in the Event Profiles table.
17.11.2.7 Configuring Command Profiles
The command profile defines the commands that are allowed on an ATS. This profile determines how a
CMS can control a panel. The default command profile does not support video verification.
NOTICE: To quickly create a new command profile, go to Communications > FlexC >
Command Profiles. In the Command Profiles table, select a command profile and click the edit
button (blue pencil), Scroll to the bottom of the page and click Replicate. You can now make the
changes you require.
1. To add a command profile step by step, go to Communications > FlexC > Command
Profiles.
2. Click Add.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 322 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
