Reset Card
If the ‘Prevent Passback’ feature is activated in a room and a user leaves this room without using the
exit reader, he is not allowed to enter this room again. The user’s card can be reset to allow him to
present his card once without a passback check.
To reset the card via the keypad:
1. Scroll to RESET CARD.
2. Press OK.
16.7.3 Delete
To delete users on the system:
1. Scroll to USERS>DELETE.
2. Press OK.
A prompt displays, confirming command to delete.
3. Press YES to delete the user.
16.8 User Profiles
See also
Adding/Editing User Profiles on page199
16.8.1 Add
To add user profiles to the system:
The creator must be a user profile type MANAGER.
1. Scroll to USERS PROFILES >ADD.
The option NEW NAME is displayed. Press OK.
2. Enter a customized user profile name and press ENTER.
The keypad confirms that the new user profile has been created.
16.8.2 Edit
To edit user profiles on the system:
1. Scroll to USER PROFILES>EDIT.
2. Press OK.
3. Edit the desired user profile setting shown in the table below.
CHANGE NAME Edit the name of the profile if required.
CHANGE AREAS Select the areas relevant to this profile.
CALENDAR Select a configured calendar or NONE.
RIGHT Enable or disable system features for this
profile. See User rights on page200.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the keypad
© Vanderbilt 2018 138 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
