3. Enter the preferred number of times the system retransmits data.
4. Press SELECT to update the setting.
16.6.8 Comms Timer
To designate the length of time before a communication fault is recorded:
1. Scroll to COMMS TIMER.
2. Press SELECT.
3. Enter the preferred time setting.
4. Press ENTER to update the setting.
16.7 Users
Only users with the appropriate user right enabled in their profile have the ability to add, edit, or delete
users.
16.7.1 Add
To add users to the system:
1. Scroll to USERS>ADD.
Select a user ID from the available IDs on the system and press OK.
2. Press ENTER to accept the default user name or enter a customized user name and press ENTER.
3. Scroll to the preferred user profile type and press ENTER to select.
The system generates a default PIN for each new user.
4. Press ENTER to accept the default user PIN or enter a new user PIN and press ENTER.
The keypad confirms that the new user has been created.
16.7.2 Edit
To edit users on the system:
1. Scroll to USERS>EDIT.
2. Press OK.
3. Edit the desired user setting shown in the table below.
CHANGE
NAME
Edit the current user name
USER
PROFILE
Select the appropriate profile for this user.
DATE LIMIT Enable this if the user can only access the system for a specified period of
time. Enter a FROM and TO date and press ENTER.
PACE Enable or disable PACE capability
RF FOB Enable or disable RF Fob access (wireless keypad, remote control)
MAN-
DOWN
(MDT)
Enables the man-down test.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the keypad
© Vanderbilt 2018 135 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
