Enrol a WRMT remote control
To enrol the WRMT:
1. In the SPC browser, select Users > Wireless FOB.
2. On the WRMT, press and hold both SOS buttons.
The LED blinks Red once and then Green.
3. Click Refresh on the Wireless FOB page to display the WRMT.
4. You can now assign the discovered WRMT to a system user.
To assign the WRMT to a user:
1. Go to Users > Users and click the Edit button beside the user you want to assign the WRMT to.
2. On the Edit user settings page, click the Unknown Fob button.
A list of unassigned fobs is displayed.
3. Click the Add button to assign the WRMT to the user.
4. On the Edit user settings page click Save.
Delete a WRMT remote control
To delete a WRMT:
1. Go to Configuration > Hardware > Wireless > Transceiver list.
2. Click the Delete button beside the WRMT that you want to delete.
When you delete a WRMT from your system, you must also clear the internal registration in the WRMT
before you can re-use the WRMT.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 226 A6V10276959-d
11.2018
To Next Page
Loading...
Need help?
General
