289
m2
D
n
S
m1 m 2
(D100)
4
(D101)
75
(D102)
90
(D103)
65
(D104)
5
(D105)
80
(D106)
85
(D107)
95
(D108)
1
(D109)
80
(D110)
70
(D111)
75
(D112)
2
(D113)
65
(D114)
70
(D115)
90
(D116)
3
(D117)
90
(D118)
65
(D119)
80
1
2
3
4
m1
(D100)
5
(D101)
80
(D102)
85
(D103)
95
(D104)
4
(D105)
75
(D106)
90
(D107)
65
(D108)
3
(D109)
90
(D110)
65
(D111)
80
(D112)
2
(D113)
65
(D114)
70
(D115)
90
(D116)
1
(D117)
80
(D118)
70
(D119)
75
1
2
3
4
m1
m2
M9029
M9165
D
S
D
S
Data Arrangement
Student ID
Philology
Mathematics
History
Sorted Data Result Array if the D200 = 3
(Starting from the appointed register )
D
Data Arrangement
Student ID
Philology
Mathematics
History
D
Sorted Data Result Array if the D200 = 1
(Starting from the appointed register )
When M9165 = “ON”, the data sorting is in descending order.
In case of the 32-bit instruction is used, all of the components at , , , and must by the format
of 32-bit.
Instruction execution completed ag. M9029=“ON” when the executions of some applied
instructions are completed (please refer to the relevant instructions).
Assigned the SORT2 instruction sort process mode. When M9165= “OFF” by ascending order;
and M9165= “ON” by descending order.
Description
Relay ID No.
The related special devices are summarized below:
Notes
(1) During the instruction is in operation, all parameters and the contents of data are not allowed to change.
(2) There is no limit on the used times of the SORT2 instruction in the program. However, only two instructions can
be executed at the same time.
(3) After the operation of this instruction is completed and if that is required to sort again, should switch the
condition contact “OFF” and then “ON”.
(4) In this instruction, the components of the data arrays for the and are not allowed overlap, except for
= .
To Next Page
Loading...