890370_0•en•01.06.2009 We reserve the right to carry out improvements
101
The product can be selected here. If the product is of the same type as
another product and if it is supposed to behave in the same manner, its set-
tings can be copied. Any product can also be deleted again.
8.4.1 Product type
The following settings for [Product type] are possible:
Articulated arm awning Light
Conservatory awning Light, dimmable (external)
External venetian blind Fault alarm contact
Roller shutter Internal roller blind
Pleated blind Vertical awning
Venetian blind Facade awning
Window Drop-arm awning
Fan, fan valve Markisolette
Fan 3 steps Fan, infinitely variable (external) with fan valve
Fan, infinitely variable (external) Fan 6/12 V with fan valve
Air conditioner Fan, infinitely variable with fan valve
Heater Light, dimmable
NOTE When you change the product type of a product already created, the settings
already made are lost and the factory settings are applied for the newly se-
lected product type (see table in Chapter 10 beginning on page 124).
8.4.2 Copy settings from...
In the [Copy settings from...] menu item, you can copy the settings already
made for another product to use for the current one. This simplifies the crea-
tion for several products of the same type.
8.4.3 Delete product
In the [Delete product] menu item, you can delete the current product
again if desired.
8.4.4 Channel allocation
In the [Channel allocation] menu item, the product is assigned by turning
the function wheel to one of the 32 channels; these are called [Channel xx]
by default but may also bear any name you assign to them.
8.4.5 Contact allocation,
Number of contacts
In the [Contact allocation] menu item, by turning the function wheel, a
contact on an actuator is assigned to the product beginning with the first
available contact of the first actuator to the last available contact of the last
actuator. The following message appears on the left if all available contacts
have been allocated:
No further contacts free!
The [Number of contacts] line is only a display (not adjustable).
Additional properties of the product type can be set by scrolling down:
Products
To Next Page
Loading...