890370_0•en•01.06.2009 We reserve the right to carry out improvements
49
7.2 Project setup with the
assistant
The assistant offers support to the dealer with the creation of a product, mak-
ing it easy to create the basic settings. It always begins with a new, empty
project. With this type of project setup, the operator must work through the
steps specified by the assistant from beginning to end. It is not possible to
enter the process somewhere in the middle.
On the menu bar, go to [Main menu] > [Settings] > [Authorised dealer]
and enter the dealer password (5858) in the dialogue box that appears.
Turn the function wheel to select a symbol from the lower selection field
Press the function wheel to enter the selected symbol in the upper input field.
Press the [
] button to delete a symbol in the upper input field (to the left of
the blinking cursor).
Press the [AB/ab/12-] button to switch between upper and lower case or
numbers and special characters.
In this way, enter the dealer password (5858) and press the [Continue] but-
ton.
Go to the [Project setup] > [Assistant] menu.
You are now located in the assistant. Before the individual setting steps are
described, the following process diagram will provide you with an overview of
the assistant. Whenever you want to create another channel ([YES]), you will
return from Chapter 7.2.6 on page 66 to Chapter 7.2.5 on page 59.
Start menu
Main menu
Settings
Authorised dealer
Project setup
Assistant
Assistant
To Next Page
Loading...