890370_0•en•01.06.2009
We reserve the right to carry out improvements
30
WAREMA climatronic
®
Installation Instructions
Attach the control panel to the base plate by hooking it on the top edge of
the base plate and then pushing against the bottom edge until it snaps into
place.
Fix the control panel with the supplied screw, which is turned into the centre
of the bottom edge.
The control panel is now securely mounted to the wall.
4.5 Installing the switch
actuators
The switch actuators are available as a DIN rail-mounted device (REG) or in
a surface-mounted or flush-mounted box. The devices must be installed in
a dry and readily accessible location. Never install them outdoors or where
they are subjected to direct sunlight.
CAUTION
The permanently routed installation must be equipped with a disconnecting
and isolating switch to separate the switch actuators from the supply voltage
(switch according to EN 60335-1, Section 25.3, e.g. circuit breaker).
Please observe the cable types recommended in the wiring diagrams.
DIN rail-mounted devices must be mounted on a symmetrical DIN rail
(35mm as per DIN EN 50022).
CAUTION
The minimum clearance between the terminals and another object equals
10 mm in the rail-mounted variant. When switch actuators are properly
mounted in the surface-mounted or flush-mounted housing type, no minimum
clearances need to be observed between the housing and the surrounding
objects.
Please note the associated installation and operating instructions before
installing the flush-mounted, surface-mounted or rail-mounted version of the
actuators.
Installation
To Next Page
Loading...