890370_0•en•01.06.2009 We reserve the right to carry out improvements
23
4.3.1 The serial number
Each device that can be integrated into the network has a uniquely assigned
number, the serial number. The number is included and for switch actuators it
is located in duplicate under the plastic cover; for humidity/temperature sen-
sors inside the enclosure cover, for weather stations on the back under the
cable channel cover and for control panels on the back of the enclosure.
Pull off a sticker and affix it to the field provided for this purpose on the last
page of the instructions of the network device.
Note down the installation location and any additional information that may
be necessary.
Keep all operating and installation instructions in a central location.
This measure allows for the unambiguous identification of network devices
during future integration.
Alternatively, you can also use the following table to affix the labels:
Device type
(affix label here)
Installation location
Installation
To Next Page
Loading...