WAREMA climatronic - Channels, Facades and Products

890370_0•en•01.06.2009 We reserve the right to carry out improvements
17
3.3.2 Channels, facades and
products
Because the term "facade" is occasionally misunderstood in regard to control
systems for sun shading products, this point shall be explained here in more
detail:
The WAREMA climatronic is equipped with more than 32 channels. Each
channel can access a single product (e.g. an awning) or several products of
the same type (e.g. roller shutters).
➊
➋
➌
Fig. 5 Example: channels of the WAREMA climatronic
Example In the example illustrated above, channel
➊
controls the awning on facade 1,
channel
➊
the conservatory awning on facade 2 and channel
➊
the external
venetian blinds of the conservatory on facade 2. This demonstrates that a
distinction according to building facades cannot be made in this example;
rather, the individual channels are referred to here.
Example Another example: The WAREMA climatronic controls all roller shutters on the
west facade with channel 1, all roller shutters on the south facade with chan-
nel 2 and all roller shutters on the east facade with channel 3. Because each
facade is controlled separately here, the term "facade" could be used instead
of "channel" in this example.
NOTE In these instructions we only use the term "Channel".
Introduction