WAREMA climatronic - Building control system

890370_0•en•01.06.2009 We reserve the right to carry out improvements
97
8.3.2.3 Building control system
This menu is used to set how a channel of the WAREMA climatronic re-
sponds to the activation of building control system.
When the BCS input becomes active, the sun shading product moves to the
position set here.
NOTE The BCS input is implemented here as break contact, i.e. BCS is active if the
contact is open.
The BCS input may only be connected to a single actuator. This actuator
must be the first one on the bus system and must be type 6M.
It has a higher priority than the comfort functions and the manual operation
and overrides these on the channels set for them.
When the BCS input is deactivated, the comfort functions and the manual
operation are enabled again.
NOTE If an external switch is used for the absence function, it too must be con-
nected to the first actuator on the bus system, type 6M.
 Press the [Back] button to return to the [Safety functions] menu.
 Press the [Back] button once more to return to the [Manage channels] menu.
Main menu
 Settings
 Authorised dealer
 Project setup
 Manage channels
 Channel n
 Safety functions
 Building control system
Channels