890370_0•en•01.06.2009 We reserve the right to carry out improvements
105
Number of tilting steps
This menu line allows you to set how many tilt steps the slats perform be-
tween the two extreme angles in case of manual operation; the preset factory
value is 6 for internal and external venetian blinds.
8.4.10 Delay time
The delay time that can be set here relates only to the 'Fan' product (infinitely
variable or switchable) with valve.
NOTE Be sure to follow the recommendations in the instructions of the fan
manufacturer.
When the fan is switched on, the valve opens first. The fan only begins to run
after the delay time has elapsed.
When the fan is switched off, the valve closes at the same time that the fan
motor stops.
8.4.11 Duration of the automatic
calibration
The automatic calibration causes the drive motor (if present) to run slightly
longer when moving a products to its upper or lower limit position to com-
pensate for slip. This ensures that the actual position of sun shading prod-
ucts still matches the target value (0-100%) even after many movements.
8.4.12 Manual mode
Different operating modes are available for local manual operation:
Different sun shading products require different control options. For example,
it is useful to be able to adjust the slat angle of external venetian blinds by a
brief move command while this makes little sense for awnings or roller shut-
ters. Depending on the sun shading product to be controlled, the following
control options can be selected:
No manual operation Dead man
Permanent mode Radio time mode
Continuous mode Toggle mode (3 steps)
Dim/adjust mode Stair light function
Products
To Next Page
Loading...